裝載機輪胎防護鏈如何安裝？

裝載機輪胎防護鏈是金屬材料制成的，安裝在輪胎上的網(wǎng)狀防護裝置，可以有效的保護裝載機的輪胎，不被尖銳的石塊等傷害，延長了輪胎的使用壽命。裝載機輪胎防護鏈的安裝所需工具：錘子、鉗子、鐵絲。
The loader tire protection chains are made of metal material, mesh protective device installed on the tire, can effectively protect the loader tires, not by sharp stones and other damage, prolong the service life of the tire. Loader tyre protection chain installation tools: hammer, pliers, wire.

把裝載機放在平坦地段，將輪胎的氣放出三分之一左右；將裝載機鏈條展開、鋪平在需要裝的輪胎的正前方；將配件取下，用1米左右的鐵絲掛住鏈條的一端；開動裝載機，注意輪胎正面與鏈條正面對齊；用鐵絲掛住裝載機輪胎的花紋，用撬棍擺正鏈條，車輛緩緩向后移動，直到保護鏈將輪胎裹全為止；鏈條兩端對好后，用連接節(jié)連接兩端即可；串好裝載機輪胎外側的收緊鏈，并調(diào)試收緊；檢查裝載機整個輪胎保護鏈的鎖緊環(huán)，使其焊口朝外，以免磨損輪胎。
The loader on the flat area, the tire gas released about 1/3; in front of the loader chain expansion, paved in need to install tires; the parts removed, by the end of 1 meters of wire on the chain; start the loader, pay attention to positive and positive tire chain alignment; loader tire the wire on the pattern, with a crowbar to straighten out the chain, the vehicle slowly moving backwards, until the tire protection chains wrapped all so far; the chain ends of after connecting section is connected on both ends; the outer side of the tire loader to tighten the chain, and check the whole debugging tightened; loader tire protection chain lock ring, the the weld outward, so as not to tire wear.